flash tube
英 [flæʃ tjuːb]
美 [flæʃ tuːb]
闪光管
双语例句
- When the flash tube is triggered, light from it penetrates the ruby.
当打开闪光灯时，它所发出的亮光穿透红宝石。 - Abstract The design rule of flash vessels, which is a cylindrical shell attached to a curved tube with rectangular section have not been established.
典型的闪蒸罐结构为带有非径向矩形截面弯管的圆柱壳，其强度计算无设计规范可循。 - The purpose is to improve the performance of flash X-ray tube produced at present time.
使目前生产的闪光X射线管性能得到进一步改进。 - We have discussed the problem of optimization on parameter of the flash X-ray tube.
探讨闪光X射线管参量最佳化问题。 - For type A, the transmitting speed and average ignition peak pressure of explosion network flash tube are about 40 times and 2 times higher than that of normal flash tube, respectively.
其中爆炸网络A型传火管的传火速度是普通A型的近40倍，平均点火压力峰值是普通A型的2倍； - According to this theory, the formulas for bubble distribution and bubble growth were derived and a mathematical model simulating liquid refrigerant flash flow in a capillary tube was established.
计算出管内制冷剂闪蒸流动过程中的压力、温度、气泡密度、干度和空泡份额的分布，并对计算结果进行了理论分析。 - This paper describes the emission spectrum characters of Er ∶ YAG crystal. Two sets of laser devices are designed& one is single flash tube with single ellipsoidal condenser cavity, the other is double flash tube with double ellipsoidal condenser cavity and its power supply.
概述了Er∶YAG晶体的光谱特性，在此基础上设计研制了2套激光装置，单灯单椭圆和双灯双椭圆聚光腔及电源，比较了两者的优缺点。 - The development of the neon flash tube detector
氖闪光管探测仪的研制 - In this paper, we try to find out a calculation method of parameters for flash X-ray tube using explosive emission cathode, according to space-charge limited Langmuir formula and electric circuit equation.
本文试图对使用爆炸发射阴极的闪光X射线管，从空间电荷限制流的朗谬耳公式和电路方程出发，寻找闪光X射线管参量的计算方法。 - A calculation method of parameters for flash X-ray tube
闪光x射线管参量的计算方法 - This paper talked about the robust design of the flash tube. The combustion performance of ignition powder was studied through the use of dynamic characteristic, the single factor optimization technology and the L9 ( 34) orthogonal table.
研究了传火管的稳健性设计问题，采用动态特性、单因素优化技术和L9（34）正交表研究点火药剂的燃烧特性； - The sulfation tests with the limestone samples after flash evaporation were carried out in the drop tube furnace.
并在气流反应器上对闪蒸后的样品进行了硫化试验。 - The analysis of leakage causes for flash trough was presented, and the wear layers on inlet tube and the baffle wear plate inside of flash trough were used to increase the wear life of flash trough.
分析了闪蒸槽泄漏的原因，采用在进口接管堆焊耐磨层及筒体上增加耐磨挡板的方法对闪蒸槽进行了改造，增加了闪蒸槽的寿命。 - Robust Design of the Flash Tube
传火管的稳健性设计